Orbic Speed 5G \u002D Restore Settings to Factory Defaults<\/div><\/h1>

If your Orbic Speed 5G powers off, crashes\/resets, freezes or runs slowly, view this info.<\/div><\/div>

Restore Settings to Factory Defaults on your Orbic®<\/span> Speed 5G™<\/span> only if necessary as it removes all modified settings including Network Name (SSID), Wi\u002DFi \/ admin password, etc.<\/div><\/div> <\/div><\/section><\/div>

Via Device<\/div><\/h2>

The Master Reset button is in a small hole located on the bottom of the device, underneath the battery cover. Pressing this button returns the device to factory settings.<\/div><\/div> <\/div><\/section>

Remove the battery cover.<\/div><\/span>

Insert your fingers into the battery cover removal notch at the left edge of the battery cover then lift and remove the battery cover. Set the cover aside.<\/div><\/div>

<\/div> <\/div><\/div><\/div><\/li>

With the back cover removed, locate the

Reset button<\/div><\/span>.

<\/div> <\/div><\/span><\/div><\/li>

Press and hold the

Reset button<\/div><\/span> with your finger or use the tip of a pencil or pen.<\/div><\/span>

Hold down for approximately 5 seconds or until the display shows \x27Resetting\x27.<\/div><\/div> <\/div><\/div><\/div><\/li>

Replace the battery cover.<\/div><\/span>

Ensure the notches align then press on the cover until it clicks into place and is flat across the entire bottom surface.<\/div><\/div>

<\/div> <\/div><\/div><\/div><\/li><\/div><\/ol><\/div> <\/div> <\/div> <\/div>

Via Admin Web Interface<\/div><\/h2>

Access the Admin Web Interface<\/a>.<\/div><\/span><\/div><\/li>
From the top menu, click
Configuration<\/div><\/span>.
<\/div> <\/div><\/span><\/div><\/li>
From the left menu, navigate:
Settings<\/div><\/span>
Restore and Restart tab<\/div><\/span><\/div><\/span>.<\/div><\/span><\/div><\/li>
From the \x27Restore to Factory Defaults\x27 screen, click
Restore factory defaults<\/div><\/span> then follow the prompts.
<\/div> <\/div><\/span><\/div><\/li><\/div><\/ol><\/div> <\/div> <\/div> <\/div> <\/article> <\/body>\n<\/html>'; var parsedkb = $($.parseHTML(htmlString)); $('#kbArticleNew').html(parsedkb);